Om du hittar något fel i beskrivningar eller om du har synpunkter på pris på enskilda produkter, om du vill ha ett paketpris när du planerar att köpa flera produkter samtidigt etc, så hör gärna av dig till oss via epost på: [email protected]

MTR DI-2

1 495 kr


2-kanalig aktiv DI-box, från engelska MTR.

---------------------------------

Quality direct boxes are hard to find in today's disposable marketplace - either quality products are too expensive or the economy version is too fragile. The excellent quality DI-3 single channel D.I. box has a mono jack input and link out socket, a ground lift to eliminate hum loops, a three position attenuator for accurate level matching, and a balanced 600 ohm XLR output. The active electronics have a purely resistive high input impedance, and so do not colour the sound. Both models can be powered in 3 ways: by a 9 volt battery, phantom power from the desk (or an MTR PPS-48), or an external 9v regulated power supply.

The DI-2 is a two channel version in the same sized box, for use with stereo keyboards or two separate mono signals. It can also be used as a balanced signal splitter by connecting a short jack-to-jack lead from the link socket of channel 1 to the input of channel 2. Channel 1's signal will then be available on both balanced XLR's, and channel 2's link socket. The attenuation switches remain working independently.


Specifications -

Freq. Res: 20Hz-20kHz ±3dB.

Distortion: (THD) < 0.005% at 1kHz, 0dBu

Output Noise: <-100dB unweighted

In/Link Impedance: 1MOhm, jack.

Output Impedance: 600 Ohms balanced XLR.

Atten. Switch: -40, -20, 0dB.

Ground Switch: Lifted/connected.

DC Input: 9vDC, 100mA, neg. centre pin

Phantom Power: +18 volts DC to +48 volts DC

Low Bat led: glows @ approx. 6v



Alla priser är inklusive moms.
Reservation för felskrivningar och förändringar som ligger utanför vår kontroll.