Audio Technica PRO 70
Slut i lager.
SISTA EXEMPLARET!
Liten smidig kondensatormikrofon för akustisk gitarr eller röst.
--------------------------------------------------------------------
• Provides articulate, full-sounding voice and instrument pickup
• Excels in pickup of acoustic guitar with included AT8444 guitar mount
• Switchable low-frequency roll-off • Corrosion-resistant contacts from gold-plated XLRM-type connector
• Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source
• Operates on battery or phantom power For use as a lavalier, attach the microphone about six inches below the chin. Anticipate movements that may cause the microphone to rub against or be covered by clothing, and position the microphone to avoid it. The PRO 70 requires 11-52V DC phantom power, or a 1.5V AA battery for operation. A battery need not be in place for phantom power operation. Battery installation: Remove the cap from the top of the power module. Insert a fresh 1.5V AA battery (“+” end toward the cap release button), then reassemble the power module. Alkaline batteries are recommended for longest life. Remove the battery during long-term storage. Output from the power module’s XLRM-type connector is low impedance (Lo-Z) balanced. The signal appears across Pins 2 and 3; Pin 1 is ground (shield). Output phase is “Pin 2 hot” – positive acoustic pressure produces positive voltage at Pin 2.
